Chipmunk build day 1

This is a build log of a super chipmunk build.  

Will use the adjusto jig I obtained from Peter.  

Day one was to remove the wing ribs and drill jig hole for the adjusto jig wires. 

Sig didnt semd me the contest balsa on this one.  and some of the ribs are laser cut and some die cut.  Very strange.  

Think I am going to like using the jig,  although it is a pain to set up.  

Knockouts for leadout wire were secured with tape and 5/32" holes were drilled for the jig wires taking care not to be near the spars.  Made a jig out of scrap pine to locate the jig holes.